for cavity-side door rather unsuitable. The supplied "miniature hollow wall anchors" can now once in a 3-4 mm thick plywood (outer surfaces of the cavity door) can not adhere. To avoid a return, I mobilized my ambition and operating a larger effort to mount the carefully selected according to the product description Tank latch (multifamily - New - standard door). So I bought at the hardware store in addition longer hollow wall anchors and as these also offered no support, I decided to rather unusual measure: I filled the "voids" behind the prepared holes (which as honeycomb cardboard, the inner workings of the cavity door filling) with plenty of anchor mass (from the tube), the hardware store anchors placed 4.5 x 4.0 and waited for the curing. To my great relief, these stopgap was successful! The solid bond between the door and Tank latch now makes a very confident impression. To mention for those who are entertaining buying this tank tie, is still the prior examination of the door thickness. My door is approximately 4 cm thick, which forced me to another improvisation (was described: to 5 cm). To ensure that the lock body in which the cylinder lock is embedded flush to the outside of the door to the fitting, I had the reinforced bolt approximately 1 cm inward push back. That is, the thus created distance between reinforced bolt and the door inside, I had to be bridged with a 1 cm thick wooden bar. Therefore, the supplied mounting screws are also unusable. I needed in this case lens heads with dimensions 4.5 x 5.0. This extra distance to the door then pulled further modifications on the lateral bolt receiving devices to be ... Conclusion: As with many products, the product description by the manufacturer is insufficient and very improved. I can recommend this product therefore only patient and skillful men and women!