+++++++++
Positive is the first impression, because all individual components valuable aspect. By separating the bracket and suction cup, can be a suction cup certainly use fine with other holders. Whether this is an added value that remains open. An added value is in any case achieved in that the holder can be mounted in 3 angles for suction cup, which can be achieved only through this separation plane.
Is the Samsung Galaxy S5 only engaged once, so it is firmly seated and so here the desired function is achieved.
+ - + - + - + - + - +
The suction cup is either on the disk, or by means of adhesive foot wherever fastened down. The holder is then snapped into the suction base. Everything can be easily separated, albeit with some force by click-lever closures. This, however, one also has to be stability.
The USB charging plug is then inserted into the cradle. Inside the holder there must be a distribution, because the side there is another USB cable, which is plugged with two connectors in the phone. Both slots are so busy then.
// Addendum:
The installation on the vehicle is very simple. By großten Saugfuss a secure grip is ensured by the setting and is an ideal location set. Negative I find here only that the holder ansich, despite the apparently good quality of materials, quite strong shaking when you touch it. Thus, a selection, for example, for setting a navigation route, not well implemented. More stability would be desirable.
--------------
Negative falls definitely on the bracket.
Once the connection of the power supply is rather poor, since a gap remains open here, of several millimeters. Although the technical side of it remains unimpressed, here a point in terms of ease of use must be deducted.
Similarly ansich at the connector on the phone. Here, however, the gap is still acceptable. The plastic head of the plug is asleep on the phone. With frequent use, I suspect that it will come here to optical defects that can reduce the value at resale.
The holding technique is also rather ansich sufficient. Below the phone is quite narrow pinched, leading over time also to unsightly scuffs, top there is a strap with a rubber sheath of. However, this is the wrong distance, so everything is strong in tension, so the phone is not centrally located, but rather Outwardly. Again, I'm going with extensive use made of it that are also left its mark. But the wear and tear are more speculation on my part. You could change with a narrower Inlet the holder the policy. This may in fact be replaced.
Really bad, however, I find that although there are a function cutout but misplaced. With great difficulty, you can adjust the volume while quieter, but not loud.
Of these, however, only the volume control is concerned.
_______________________
If one were to make the bracket ansich wider, you could use the super Samsung Galaxy S5 with a protective covering, such as the and still have the same effect stable Belkin. By means of the Inlet could then still a Galaxy S5 mount well even without a protective case.
Furthermore, one would have to change the function cut-in that you can also use the button.
My conclusion is therefore that the 35.31 is quite a reasonable price for this support,
because it is indeed ansich quality, but also shows some shortcomings, which would not really need to be.
// Addendum:
Even with the shortcomings in the operability when the Galaxy is already locked, the price is still justifiable. Still, I would replace the holder immediately if Samsung sells its own bracket.
/// Supplement 2:
Unfortunately I have to tighten further to frequent use of the mount my judgment. You've clicked the cell phones you have been careful that you actually take the correct position. When "Snap" I'll inevitably be on the side button of the mobile phones. As if that were not enough, is the really big problem that the bracket is simply too shaky. Even the unlocking via the fingerprint does not work properly, because the bracket too much give in. So it looks like with the operation of the touch surface. Really the whole thing is not purposeful.
Also to solve the side plug connection, proves difficult because everything is built up so unstable. Appearances are deceptive here very.