As such, the device is really useful related. In my copy, unfortunately, the static friction of the tilt in the direction (bearing in the fork) was noticeably higher, so you could hold the camera 30 ° from the horizontal (RX-10 with about 800g). In the RX100, the influence was stronger by the lower weight, If you go on the move, keeping quiet but in between, is a stiction and stuttering are noticeable. The effect is unfortunately distracting and therefore the unit returned. The other two camps were the extent applicable. Slight friction is even necessary per se in order to lead the camera better. Structurally, the camera mounting screw improvable because you always need a coin. The terminal extension is a little too far. The fact that the center of gravity in front of the handle, carrying more burdensome (torque) than other structures is where the emphasis goes by the handle.