I use the saw to make wood and wanted to be independent in order to work in the forest can. Whether the saw also keeps a continuous daily use on building sites or in the forest stand, I can not say. For the price of about 100 Euro but you get a well-made saw. So far I have good 40m timber made with cross-sections up to 45cm and it clatters nix or ringing. I use a sword and 40s actually have to cut just before small timber up to 25cm diameter. I would recommend them to my friends.
small addendum:
I have also contacted the support because the saw was hesitant start. I am very pleased with the response and answers of German support team. I was recalled, was an exploded view of the saw and after the tip to start: it now works perfectly.
For those who still try with the start time:
Set the ON / OFF switch to I.
Push the throttle lock and actuate the throttle at the same time.
Pull the choke lever all the way out and let the throttle lever.
Repeatedly press the fuel pump to pump fuel into the carburetor.
Then pull the starter cord until the chainsaw noise makes to jump.
Now shove contrary to the instructions the choke lever manually and again pull the starter cord.
Run when the saw is running a few seconds so that they can accept the gas.
For me it works perfectly so. I clean the chain with compressed air, MX-14 cleaning concentrate and loose the chain after working at any tension after cooling to avoid. Who has noticed that too long enjoy his chainsaw.
Conclusion:
+ Power (Private)
+ Processing
+ Price
+ Support (German and quickly both on the phone and email)
- No keyless chain tension possible (not relevant for me)
- Screw for the chain tension I would have liked on the side (not tragic)