This set of Wera I have in my workshop cupboard - for the spontaneous or handle a specific task. The compilation is quite lush, but functional, so you can not go wrong with this purchase.
The default rate (4.0 x 100, 5.5 x 125; 6.5 x 150; PH1 x 80; PH2 x 100; PZ1x80 and PZ2x100) must in every workshop; this is from the Kraftform Plus series and the blades have roughened peaks (Lasertip) that gently "bite" into the screw and ensure a better grip and improved power transmission.
The two small VDE slots are also from the Kraftform Plus series; I find that especially with small slits under 4mm quite handy because often slip off otherwise, if you want to tackle a stubborn screw something strong.
The two Chiseldriver have a hexagonal profile blade, so that you can pack them with a wrench; Also you can cut with a hammer hard on the steel cap head - can indeed, screw you thus.
The booklets are grippy, soft fitted in hand and with non-roll. Unfortunately, without cross hole.
There is also a small holder, so that the screwdriver clearly sorted and ready to hand to the set.