Quite lousy workmanship

The case looks like it would have an electric hobbyists themselves timbered together. Everywhere sharp and with gap (it pushed above it rattles). What are these cooling fins or the distance below, where you can look into the case, I already understand not. As if we were here from adding a hard disk, but a processor which takes a lot of convection. After opening the case, then you can see even a problem. The board with the electronics goes through the whole body (but only in the area of ​​the connectors are soldered components) and is fixed only on the plug side. Shortly shake and you hear rattling the next component.

The housing is good if at all on the go in a road case, but at home / at the office on a wooden table, the housing not belong.

It is also very large. The housing has the dimensions of 150x79x22. My 2TB drive has a size of 100x70x10.

Last one must not forget that there is no shielding in this case, the 3.0 is essential with USB if you have Bluetooth / WLAN (also keyboard dongles work with WLAN) near. USB 3.0 radiates namely as hell. However, I have not found a single case where the matching aluminum foil was there. But if you bring already built plates, all of which are shielded. Anyway, I expect for 30, - EUR that it is perfectly finished.