Radio transmitter / receiver

The unit is two in eins.Es can both transmit as well as receive.
Eg if you have three of them, the following configuration is possible and very practical:
The first device is used as a hand-held transmitter / trigger
The second device befinet at the camera with the respective camera Typical connection to trigger the camera (Nikon, Canon etc).
The third device plugged into the generator with the Studioblotzanlage PC to 6.3 or 3.5 jack in the Synchbuchse.
I operated my "transmitter", the camera will not only, but also sends a radio signal to the generator to
to ignite the flash.
That's pretty awesome especially since it does not only work properly but you also a complete further Funkset to
Triggering the Blitztes saves.
Previously I had two radio sets: one to trigger the camera and another for the flash fires.
This meant that I had to stick two devices to the camera: a receiver and a transmitter.
The devices are slim, super processed and made of highly quality plastic. Nix wobbles or knarrzt.
One of the parts happened to me like before from the table onto the concrete floor-Nix.

As a professional photographer, I also know the prices of comparable sets. Apart from the fact that at the time to my knowledge no other device out there that send out simultaneously !! can receive (is time the transmitter or the receiver broke, you can either cut down the whole set in the bin, or to buy one of the two expensive after), there are of me an absolute
Buy recommendation; in this price-performance ratio and by outstanding processing, you have to give the Chinese people, unfortunately, Top !!!!!!!!!!!
I had other, even inexpensive sets made in China because (probably from China) too expensive real me the much more expensive, here in Germany, purchased in stores products
They have also performed their service for many years without complaint, but were not nearly in their quality processed
as good as this Yongnuo.
Tip: if you want flash unleashed with clip-on, also the Yongnuo YN560 should look Speedlits who have already installed the receiver for these sets !!!!! and costs about 65 !!!! per unit with guide number 58 (at 106mm in 35mm about guide number 33, I think)
If you want to flash ITTL and perhaps Kurzzeitsych needs, the times look at the YN 622E radio system with the associated iTTL clip-on (460 or 565)