The following topics are described in more detail:
1) Buying
2.) Delivery / packaging / content delivery
3.) Mounting / Operating Instructions
4) Daily use
5.) Summary
6) Recommendation / end
_________________________________________
1) Buying
It was a long back and forth until I finally could not decide for a bicycle computer. I had already many bicycle computer. Because some models of Sigma and some cheap models from Hofer / Aldi were also there already. Most say yes, Hofer / Aldi electronics can forget. Well, this view I do not share completely. I had previously a unit of Sigma for more than 100, with whom I had nothing but trouble. Of course, I also have experience with Hofer / Aldi devices who in my opinion relatively long served its purpose for the price.
Now I looked around again and found this device very attractive and cheap, so ordered through Amazon.
2.) Delivery / content delivery / packaging
Both the order and the delivery are indeed handled very quickly from Amazon, so the cycle computer was already after 3 days in the mailbox. That's really fast.
Aussenrum was of course the standard Amazon box to see inside then the cycle computer including accessories packed in foil and cardboard in. All very safe, much can not actually happen. I was satisfied.
The delivery included the bicycle computer itself, the rubber belt to attach the speed sensor, the computer bracket, assembly instructions and operating instructions
3.) Assembly
So if you follow the assembly instructions, can not go wrong. The installation takes about 15 minutes.
It unpacks everything and chooses a good place for the cycling computer. Either directly on the handlebar or on the straight connector, between handlebar and bicycle frames. Depending on the need to turn the computer holder. For this purpose it is necessary to remove the 4 small screws, remove the mount, turn it 90 °, reinsert and secure it with the screws. This is easy so far.
Thereafter pulling the protective film, which protects the applied adhesive on the bottom of the holder, from the holder and placed on the handlebar. Now you just have to tighten the rubber strap around the holder.
Now to get to the sensor. Insert sensor into the bracket, place it on the bumper and secure it with the rubber strap. After the counterpart at the same level with the sensor clamp on the spokes.
Use bicycle computer in the bracket. Initialization starts, so turn on the front wheel and wait until the speed is displayed.
The manual is very simple. Everyone should know about here.
Done.
4) Daily use
Operation:
The cycle computer can be operated properly. Neither in the settings even in the menus you have to wonder how to do that right now. All buttons are easily accessible and have an excellent tactile feedback.
Special feature:
The cycle computer is equipped with a motion sensor. What does that mean? Conventional bicycle computers activate themselves only after about 2-5 revolutions of the front wheel. This model detects motion of the bike and turn on automatically. It is sufficient if it sets up the ajar bicycle or move the handlebars.
Functionality:
The speeds and mileage information both agree pretty much. The speed is quickly calculated and displayed accurately.
5.) Summary
Positive:
+ Cool Design
+ Price / performance ratio very good
+ Easy to use
+ Very cheap
+ Assembly not very difficult
+ Accurate speedometer and kilometer counting
Negatives:
- Rubber strap a little too small
- Holders filigree
6) Recommendation / end
I would highly recommend this bike computer to 95%.
End:
If you review helped or has fallen, I would be happy about a Like, "thumbs up" or.
Thank questions simply a comment.
