Positives:
+ Good cooling capacity (without load: 21 ° C, full load: 58 ° C, with 19 ° C outside temperature)
+ Quiet 120mm PWM fan case (and two other fan Klemen for a second retrofit 120mm fans on the back of the radiator)
+ Relatively low height (156mm, also slightly narrower housing suitable)
+ Standard RAM modules without high heatspreader fit at least among fans (if one moves up the bit)
Mediocre:
* Installation is simpler than its predecessor but still nothing for Grobmotoriker; Instructions, is also OK
Emotionally :)
* At one point the assembly was critical: As you tighten the four mounting screws for now? Without that one CPU or motherboard destroyed? Of course, with feeling? !!! Carefully and always nice "crosswise"! Good Luck!
The tension clamp of the radiator had after tightening the mounting screws a little something horizonales game. The game came by the somewhat inaccurate fit of heatsink and mounting clamp to pass. This could be the radiator horizontally to the board rotate somewhat / blurred. After drying of the thermal compound of the cooler was no longer twisted / are blurred. Probably also helps the weight of the radiator, which then acts as a downward pulling force when the motherboard is installed into the housing. In the completely assembled state everything is sufficiently strong.