The device is with us only used as a playback monitor for DVD's (with a DVD player via Scart).
The Pre-set adjustment Auto-wide but eggheads produced with the setting 'Zoom'
I have a perfectly scaled image. The 16: 9 - although films do not have a black border
up and down but the screen surface is flat 16:10, because such a thing is inevitable.
But my favorite films (ported TV adaptations) seem to need exactly this format.
You are fully adhered is cut without the bit and there is no distortion visible.
As I previously used a 51cm tube TV it should be an output device which similar
Can display sizes. Of course, the tube TV had an aspect ratio of 4: 3 and movies were only
depicted as a narrow strip, and even with Zoom it was not particularly happy because right
and was left well cut 1/3 tel. Well ... snow from the day before yesterday.
The Abstrahlverhältnisse not correspond to the tube TV that I could through the tube curvature
(15 year old part) almost in every angle look as long as I somehow before
Mattscheibe was. The 170 degrees (horizontal) from the LCD are embellished details and available is approximately
+ - 60 degrees (120 degrees) at horizontal angle. Because PC monitors are already making more.
Vertical not so much opening is indeed required but indicated 160 degrees I can in
Confirm any way. Downwards the image at -25 degrees is already negative and broadcasting
is only upward. At +45 degree illumination interference is which migrates as a dark bar visible
and about going back there good almost to a right angle.
Vertical is therefore a maximum of -20 to +85 corresponds to 105 degrees vertical adequate (with a dark zone).
Strange to me is at 0 H / V 0 degree viewing angle I have an approximately 30% darker picture than
at 0 H / V 10 degrees so must see on the television. Optimal viewing angles are so
only +5 to +45 degrees vertically and + - 60 degrees horizontally.
Power consumption is reasonable a 51cm tube TV. At full brightness it sucks measured 50.5 watts
(51 watts are given) and at night (closing credits, etc.) he goes down to 38-42 watts.
Apparently the backlight shuts down slightly in dark images.
The price is reasonable for a 22-inch model which has a neutral color reproduction and high resolution.
I have absolutely not sold but appealing applications where there is better
Man / woman more money needs to lie down.
A / Ausschaltprobleme does not exist. After completion of the show is my power strip without power.
Stdby except I can not measure it because my meter clean until 1.1 watt power output
Measurements carried out and the STANDBY consumption is lower.
The settings are well accepted in a flash / EEPROM since I only the basic settings
Had to do 1 times. Time is for a power-off away.
