Unfortunately, the manufacturer has chosen to incorporate only two LEDs on the charge level of the Sixaxis controller, the charge state of the Move controller is displayed on the built-in controllers LEDs.
In order for the rear of the controller can be read LED had to be arranged this backwards, so it is not possible to control the charge state of the rear Move controller from the front.
A positive feature is that the included power supply covers a wide range of mains voltages and is connected by a standard barrel connector to the charging station. However, the manufacturer could provide the cable quiet little longer.
It is also positive that the straps do not need to be removed to the Move controllers for charging.
The charging station is very stable and not slippery thanks to four rubber feet.
Conclusion: The charging station is a good choice if two Sixaxis- and two Move controllers should be loaded at the same time, in particular the selective uptake of Move- and navigation-controller is a positive development. Installation in an enclosed rack is impractical due to the charge control and the cable could be longer.