Stable mount with pitfalls

The metal wall bracket is processed very solid. There are 6St. 10er dowels with screws for wall mounting attached (3 top, 3 below). In a normal sand-lime brick wall, I think it's oversized. For my 37 "flat screen with 18 Kg weight ranging Me 2 screws at the top and 1 screw at the bottom completely out. The screws are very nicely covered with a black plastic sheet. Even for fixing the VESA-rails on the rear wall of television were plastic sleeves and screws attached, so that the holders do not rest on the TV housing. To align a water truck-fin is attached, which is however very inaccurate.

For installation missing a mounting template and a useful manual. Since I had to fit my holder very precisely in a rectangular gap with underlying DVD player, was a good measure essential. Nevertheless, I have the holes accurately measured, the device then hung whole 4 cm deep as planned!
Reason: Even if the holder is processed very solid, are the long arm with his joints but after enormous. The holder can be in almost any direction to move, not only in height. So I had new 4 cm higher lying holes drilling.
Where it does not depend on such an exact fit, this problem will not bother probably. Then I would have awarded 5 stars probably.

The hanging of television via the pre-assembled brackets is extremely comfortable. Also for servicing This is certainly a smart solution. After hanging the holder can simply locked up a single out and even me a padlock (not included) secured.

Small plastic loops on the swivel arm, ensure convenient cabling.

All in all, a thoroughly recommended bracket.