These are exactly the same case, which will be offered by other providers for 80 and more Euro. Inside are four layers of plastic, a dimpled in the lid and three each about 47 mm thick in the storage space. The top layer is innheralb of 20 mm edge pre-cut in 15 x 15 mm square, which can be individually or out in separate blocks to divide the interior into compartments. The lower layers you have to then trim to fit leg with a knife needs.
I bought the suitcase for transporting a DJI Phantom 2 quadricopter and after appropriate processing of the foam fits this well in the trunk. In case if it has a very good value for money compared to other offers. It would be nice, however, if all the foam layers were pre-cut so that the adaptation of the interior design would be easier.