Unfortunately, she has a design flaw. The shell consists of 3 parts:
* Inner silicone layer
* Transparent, H-shaped side part
* Matt coated midsection
The middle part of thumbs up and down around the iPhone around, the H-shaped side part left and right. At the points where the encompassing (ie at the level of chrome frame of the iPhone) touch these parts, the middle part is not on about the iPhone, but on the side panel. Certainly another good protection against scratching the chrome rim when the center part shifts times.
But there's the rub: These bearing surfaces at the corners are made thinner, since yes overlaps the side part by about half a millimeter the midsection. In regularity these overlaps now breaking with me upwards away because the material fatigued by the constant pressure change in everyday use. I have the case already once exchanged to guarantee, in the novel is at 3 months already the top left corner have been broken, a little later all four corners were gone, now the entire lower strip has passed through the dock connector.
I will as soon as possible need to make the next exchange!