The assembly of the arm is really easy. The lower part is simply screwed together, with or intervening or extension. The actual holder of the iPad is simply plugged into the end of the arm and there also tightened again.
The processing of the parts acts in principle very high, the terminal, the extension and the arm are made of metal. So they are relatively heavy, but also very stable. The terminal is on the sides they mitdenen on attached to the surface is rubberized. So you need to not have to worry about damaging something during installation. Very handy at the terminal is also that you can attach the arm in two directions at her. Once out of the terminal upwards and once from the terminal in a lateral direction. The respective unused port hole can hide by a rubber stopper.
The arm is relatively difficult to adjust for it holds then also in his new position. The extension can simply be screwed down between the clamp and arm. The extension is a rigid straight piece of metal.
The actual holder is not to damage plastic to the iPad. He seems, however, fairly thin and not very stable, this is for me, however, not a minus point since strengthened firstly by the iPad and will not be too many demands on the other in normal use this disk.
The included clips are well suited to the charging cable to the iPad to fix, very well thought along. When attaching the supplied sheet I had a little superior because in the instruction manual, no suffering is no evidence available to it. But even that you get relatively good way without guidance.
Conclusion: I am very pleased with this bracket. The iPad securely holds the bracket and the bracket is sticking to my table. When using the mount this does not wobble and you can the iPad can be used well in this. I can only recommend this mount all that is in search of a good mount. If I notice something in the course of time I will add it here.