I am ITler, but it was quite complicated to get the router at home connected to the grid. The problem was as a static route between the ports set for dynamic IP because prefabricated options or have been missing wizards Ping into the net from the router and the PC went anyway. For this to work after a reset only port 1 access to, so if you constantly reposition the normal LAN where the computer wants config is on a different port. In addition, the interface has not loaded when I plugged a second router. Definitely has problems with Firefox because IE hats then folded folded hours rumprobieren firmware update from 1.4 to 1.5 and then hats suddenly, there was even a wizard and the function has previously been lacking masquerade Cable Modem was there and went internet. Who buys this router must do the firmware update. After the firmware update has config garnicht works more via firefox and has remained so, he must therefore accept or chrome. Then, a further problem with the bandwidth. I wondered why I got in speedtest.net only 90Mbit at a 120M line the 119.95 normally creates. It turned out that the NAT loopback problem was. Disabled and now everything was as it should be. I do not know why this is so, well, I do not need that anyway so it's ok. Otherwise, the router, however, as already mentioned by other top bichts for beginners. Well with Firmware Update and the Wizard gets even an amateur towards the Internet. The package does not include a user, this one has to search themselves or by the manufacturer invite [...]