A contented Hello from me. I must say the positive reviews have influenced me to buy back. But that was not a mistake, because I write so well just a positive. The following should be noted. Thorough cleaning in advance is one of the key points then pretreatment with primer. The foreknowledge of geometry (important), how do I start, where do I start without me even getting in the way in terms of primer and curing time about 30 minutes (do not glue wet), which pattern I lay. I have placed offset by half the plates then it falls upon application easier. It is best to start at the side of the door opposite (Helpline advisable). Since then you have the whole and half boards and pieced is then on the wall where the door is. If you realize that it is not parallel to the wall, stick on and focus only on the plates, the rest you have to cut into pieces on the wall. The primer you withdraw the reference to the right and then worked eyes towards the door so that is the finished floor behind one and the clear primer ago. Never underline all the ground at once with primer if you must about it again, always in stages because it should not be run over. The right angle should always start from the plates and in the run / angle to the door frame be otherwise if it falls on the joints run away from there to the left or right. When the primer is clear you have when installing only one attempt, the board sticks so strongly that they would collect NOT again. Have the plates glued onto an existing laminate and am thrilled.