The film is kink-resistant in an envelope in which a solid cardboard packaging is with the films, the films are protected on both sides with foil. There is a thin mini cloth and a squeegee while Papp. I have due to some bad fit 2 films used, the first I had done up to the speaker recess and the front camera, unfortunately is then down to the corners on the chassis frame to, the 2nd attempt, I then set about 1 mm higher, so is the speaker hole and the decentrally not the front camera in the recess, the film sits but flat on the glass, all around is about 0.5mm air, where it is already tight at the corners, the Wiko Bloom is above and below yes deduct 100% square as the film, a film for correct and re-use does not need to try one that is not working. It is important that you absolutely dust-free working, even the tiniest speck of dust results in a bubble under the film, for me there are fortunately only a very small top next to the camera. The cloth which is, is very, very small, so you have to if you use it, clean the screen with 2 fingers, but what quite hard and took me a bit annoyed.