The pump is completely disassembled, without tools. Even the manometer. Simply screw counterclockwise. All are ordinary right-hand thread. I do not know that there is to go wrong.
Among the criticisms of my previous pump can be found not only in this. Only times the size. The dimensions of 30 X 5 X 3 cm are the perfect compromise between usability and size. Large enough to reasonably work with it and not ever to need until the tire is fully in order to be able to be still in a relatively packed rucksack slender and short enough.
Next, it is the first pump for car valves, when I do not have to watch how fast I abschraube the valve head from the valve, to avoid losing air.
Mostly you have to at the point where the monopusher leaves the valve, turning a little faster to lose as little air. Or when a clamping lever is present, this fold as quickly as possible. (A short hissing sounds) If we make it too slow, it hisses longer and you lose pressure noticeably.
In this pump, a sibilant is not on the first place. This will keep the pressure on precisely the set value.
So completely silent, I have experienced the withdrawal in any pump. Great.
Then a tube is present. This exercise is of no lateral pressure on the valve, which can been attached directly as a standard hand pump. Nor is it so important by the sufficiently long tube where the valve is just. No deal turn the wheel in the optimal position is necessary.
Also very handy: At the valve head pressure is a key to drain available. The handle is quite small. A larger grip, however, would make them turn bulky. And against a folding handle, I would not like to swap. So as it looks super strong. The handle can, however, grab still good enough despite the small size. The perfect compromise just.
Like everything at the Lezyne Micro Floor Drive.
The pump consists almost 100% of aluminum.
Plastic was only because used where it makes sense or is necessary:
- For keeping the piston rod
- For the sleeve of the manometer
- For the cuffs, clamp the hose
You might have to make the cuffs made of aluminum ... but that would have driven the price of unnecessarily high. Especially as the cuffs would be very smooth not to damage the hose. High surface quality = high price. In addition, since one would also need to plan sealing rings because aluminum is not so adapts as plastic. This would have the price even further driven up. If the pump should therefore be cost 70 or 80, you would again what had to complain. Even so it has some already too expensive. Plastic makes sense at this point simply.
One such exemplary product manufactured one gets nowadays only rarely in the fingers. Thumbs up all along the line! Can you hesitate to recommend.
