Shipping and packaging
The first flipchart this order went irgendo lost along the way. Call at Amazon, immediately went a new top on the journey, everything! The package was then relatively battered here: The middle leg was broken down through the cardboard and telescoped to perk up a meter out of the box, because you have to pay yourself first screw the fixing screw. Made stupid! Rest of the boxes should have verschmuddelt DPD, the packages of which come here often in very questionable condition.
Assembly and material
When pulling the legs straight, the first minus point: the point where the fixing screws on the right and left leg FACTORY were tightened, the coating was from time to time to see the bare metal already. Short visual inspection of the board surface, directly next downside: Wherever holes in the panel are, in some places was also already the coating off and rust visible. Sign up now to minimal, but hey, the thing is NEW. Also on the hinges of the block cover above you can see these tracks already. Then I tried to screw the side handle, the next downside: There are regular Phillips screws (Pozidriv), but you have because of the position of the (firmly welded) left standing leg just 4.5 cm of space for screws. Have been really good tool, but as fits no screwdriver and no ratchet between. Maybe you go to a single bit and pliers, but that's just made damn stupid. Especially since these handle the entire weight of the part must carry and should be screwed stable.
The side arms
Next, I wanted the "fold-down" mount side arms ... ääähm, what ?! Yes because of folding: The parts are clipped on the back via magnetic stripe on the board. That is so NOT in the description, I would also not interfere, however - if it would work for! Once the flipchart you put on when removing the side to retract the legs, the attached metal parts flying merrily and loudly through the room, because the magnets are too weak. Beautiful even if you transported the part in the vehicle ... what a moronic design!
Paper Holder
These are two Plastiknüppelchen which can be clamped from the front to the board and then moved. Hmph. It is handy that you can use in this way different Blocklochungen. Whether two parts rich and I like the system, I do not know.
Stability
Legs extended, erected ... Hmph. Wobbles. As long as you want to see only beautiful things on it, all is well. However indeed written on a flipchart times, had the thing actually appointed as a mobile whiteboard. Another thing: If you want to place the part in the assembled state, the average works out a foothold because the mother is apparently not sufficiently tightened. If you then maybe n markers, tablet or Presenter has in hand, there's ungalante Wurschtelei. I'll try to see if a tightening of nuts brings additional stability, but I'm not happy with this mobile Filpchart permanently.
Conclusion
Toys! All this would be absolutely in the frame when the thing is no more than it would cost twice as much as a Noname-cheap Filpchart. From Magnetoplan I expected more: Packaging is insufficient rust on board, chipped coating where the adjusting screws for legs grab handle screwed only with great circumstance, side arms do not hold on board. I'm going this weekend to test the flipchart at a seminar because I need it (Shipping wg. Lasted far too long the first, lost packet) and then very likely return.