So now hang two new beautiful lamps at the house. Unfortunately, I come with the lamps not quite clear and pull the disassembly and return to consider ... The good pieces are steadily illuminated. As a problem or approach called the manufacturer: Off 8 hour mode or check connection to the power grid. How do I turn these 8-hour mode? That is not there, unfortunately. Maybe so how do I enable it? This would be equivalent to activating the test mode (which irritates me again to instructions. Unfortunately, I did an experiment which did not continue. According to the description it controls the mode on the wall switch off-on-off-on " No Success .... Connected the lamp is fair enough. what should it be wrong? (Blue to blue, brown to brown and yellow / green to yellow / green. So neutral to neutral, juice to juice, protective conductor to the protective conductor) hmmm I'm still a little trial and error maybe there is a solution to my problem If I can solve the problem I update like this review Oh yes, I once against the advice of the guide (there is no justification "energy-saving lamps are not recommended") tested an LED bulb. Not Recommends translates into reality: Such light means you can not use this lamp because it then similar rumspinnt as a light organ.
So as promised to supplement the review. Both lamps were broken. Replacement lamps operate on absolutely exceptional service of the manufacturer properly (LED bulbs but are still are unfit they initially strong and fast flashing). It looks like that the control module for the new lamp is different. Assuming you can buy a lamp of the "new" version, the lamp is properly. Unfortunately, the packaging looked the same, so that is not apparent on what you must look for when buying ...
For me, here the story ends. What long wärd is ultimately good.