- The glass tank is sealed up and down with O-rings. About this rings the tank has to be pushed over. The upper O-ring was too small, so that the tank was leaking above
- The lower O-ring was really too thick in diameter so that the tank only with much effort (even though I greased him) made up slide
- Both O-rings of the tank had to be replaced so to be able to use the device properly. Those who have no extensive O-ring assortment, as has a real problem
- The glass tank has just been cut and not reprocessed at the ends. It is thus quite sharp which will sooner or later destroy the O-rings. Also no spare tanks offered by the provider.
- For the hole for filling the tank is no plug or not screw it. Just as it is delivered, you can not lie down because it would expire this clone. A thread is cut, but in the opening. So you can get a small screw and screw in there. I've seen another clone where the fill opening a silicone plug is included.
I think that all these criticisms do not should have been. It would have been no problem to take the correct O-rings. A screw or a silicone plug for sealing the filling hole would not have made the device much more expensive. And the glass tank, you would have at the ends also need to grind only briefly.
Two stars there because after I've fixed all the shortcomings, the laboratory equipment with a knotless really taste, and dual-coil winding, with a huge steam output. If these small but absolutely unnecessary defects not that would just leave so relatively avoided in the production, I would give full 5 stars.