First, the case is somewhat different than in the picture. The plastic box is also equipped with hard plastic inside and not with foam. On the back is a rotatable belt clip.
Content Bits: Phillips 1-3, 1-3 PZ, Torx and Allen 10-15-20-25-27-30-40 4-5-6
The quality can I estimate difficult, but looks ok.
Content Aufstecknüsse (1/4 "): 5-6-8-10-12-13 (yes, the 7 Series is not there!)
The quality seems to be high. The outer surface I chromed.
Extension: bitholder 6cm with magnetic and mechanical locking
Adapter: From bits to 1/4 "- about 5cm long
Both parts are in order.
The "hand ratchet" is but low-grade. Optically very good and the changeover is haptic also super. But the "ratchet" one notices some strange noises and charged to the gun, for example, by attaching a nut which you hold his hand, comic glottal stops coming from inside. Clear the product is not designed for high forces, but this is almost scrap levels.
The ratchet can be used from both sides. Once there is a receptacle for bits (or the extension or adapter) where the change takes place, moment during over a direct 1/4 "Imager is available.
Too bad, I would have more quality gladly paid 20 euros more. I would not necessarily buy it and hope that the product better beats, as I suspect it currently.