The material itself is very thick and soft. But this is at the same time also be a problem. I personally Bügle my shirts themselves and need a more hard pad, so that is pressed to be ironed material do not get too down when ironing. This often creates new wrinkles, because the iron then the depressed material "skips". The material support sits not as firm and Spack, as we would have expected it. Moreover, the material absorbs only little steam from the generator iron so. After 2/3 Shirt according to the effort condensation dripping from the underside of the surface to the ground.
Especially for the low-cost material, therefore a star deduction.
However, the experiences make for light material like shirts to. In Jeans etc. The board is top and absolutely recommendable.
