I had 4 of these films. In the end it has to be done only one stuck halfway bubble free. Since the films are not particularly accurate measured, they can not be glued precisely. It is indeed only about 4mm, precisely this is not, however. Worse, is rather that not punched the hole for the sensor display on the slide there is where it should have been. It is about a cm beside. Thus, the sensor is glued to the foil. Consequently, this has to be edited manually! Unfortunately, this is only possible due to a very sharp, pointed knife and a lot of patience. Would not this film just bad and they established would fit so they would actually quite ok and easy to operate ... Positive is that many accessories with detailed instructions for applying the foil. Nevertheless, it is almost impossible this dust free and therefore without installing air bubbles. The Staubfusselklebestreifen is for this big film much too small and unusable. The microfibre cloth leaves on display more than a lint Piece of toilet paper. Overall, the good intention can be seen, but there is also the second star. Also the service is to be mentioned that really works very well (This is serious.) Respect! As for me, the success rate, the successful attachment of the film, with 25% is devastating, is a more positive Rating not in it. My conclusion: Stay away! This film does not fit the (10.1 inches) Odys IEOs Quad Tablet!