Then the experimental Soft 05/11/2014 was v. Installed. This is really only suitable to test the functions of the device. Machine processed very well and produced lowing concept.
Uploading VTI 6 did not work, there probably too old for the bootloader. Latest VTI 8.0 v. Nov. 2014 with no problems.
Had to search on the net some jitters before configuring. But doable with a little basic knowledge and patience.
Have only additionally EPGrefresh plugin installed-runs. UPNPclient plugin scrap: does not appear in extensions,
therefore not configurierbar.
Consumption: operating about 20-21 W, depending on the HDD, Standby 17 W-too-actually I use nicht.Deepstandby 0.5W.
Since the receiver in about 50s. it starts make sense. Big fan base and WIKI!
Disk configuration Extf3 (Samsung 1TB 3.5 and Samsung HN-M 101) without problems-also Recording. Device has been detected on your network configuration in the PC immediately and I was able to access it. Transfer (GB network) about 50 MB / s HDD 3.5 7200 !! Best value I've ever hatte.40MB / s HDD 2.5 5400.
Have connected and led out the power of the internal interface e-SATA drive. Goes without damage by removing a tuner plate.
Heat: no problems: Temp display about 37 Gr (fan ca.1000U / min) Tuner:.. A little warmer in service search. Should even make 3.5 inch no problems with internal HDD.
HDD shutdown wonderfully configurable circuit apparently over data line, because regardless of the power supply.
HD picture very well. Switchover about 1-2s
Later, ev. New. 4 stars because EPG not very comfortable. And I also sound / radio sound comes from something rattling.
I think the sound itself could still do something.
Configure with a variety of tools available on the internet-only research! Can absolutely recommend the device!
