Well, if it does

- PS0002
- Brother HL-5040
- Speedport W 700V (firmware: Version 3.15.020)
- ThinkPad R40 and TravelMate 4021 wireless

BUT: Why did suddenly after several hours of fiddling, is beyond me. At first I could the web-based configuration menu on the PS0002 partout not appeal, either directly via RJ45 from the notebook even on the router. Yet could find of the Logilink PS0002, the "Print Server Configuration" program.
Then I performed a firmware update for the router, then redecorated reset the router to factory defaults, then the wireless and DSL access and also pressed the RESET button at the PS0002.

. [The LOGILINK-KD said: "You can not try in advance to reset To reset the print server the print server, you should go for about 8 - press 10 seconds for the reset button and the print server in the port for about 5 seconds by disconnect the mains The factory preset data are then:. IP = 192.168.2.2 / subnet mask = 255.255.255.0 / username = admin / password = 1234 then check whether the LEDs respond as follows: LAN LED = lights when recognized Network / Flashes wennn are sending or receiving status LED = lit at the start of the print server and disappears after a short (max. 1 - 2 minutes) self-test Ready LED = lights when the PS0002 is connected to power "].

And suddenly everything went by itself: I could speak to the web-based configuration menu on the PS0002, then I still according to the instructions ("Installing a print server using a TCP / IP printer port Windows XP SP2," there's the Logitech Support [email protected] ) The printer installed. Instead of the proposed therein "Printer Name or IP Address" I entered 192.168.2.2. Ready's it and works just fine.

JF