Well - just be careful with the internal dimensions!

Material / Design:

The outer material is a riffelig structured black plastic plate of the material thickness around her like a yogurt cup.
This black, riffelig strukurierte plastic plate is on a hardboard (The material from which today güstigen furniture are the rear walls, but slightly thicker, guess 4mm)

Interior (similar neoprene) lined the suitcase with a black, 2mm thick soft foam material.
The material is soft, but offer only enough protection for sensitive goods due to the low material thickness.
For this purpose you should insert an extra foam rubber mat / liner but then Nocht.

As another customer wrote, the material at the beginning of something smells "chemical" - presumably the "good" plasticizer.
After 3 days open to the warm boiler room was the smell and no longer bothered noticeably.
Tip of the grandmother:
2 days reinstellen a bowl of vinegar with the lid closed, then two days a cup of salt and last two days, a handful of coffee beans (with lid closed).
Neighbors; "As well (both not try, do not have time for) parking for few days a plate of pure cat litter, do's

Who the lining is too thin anyway, who can rip out relatively easily, the fiberboard is then slightly sticky and stick itself purely thicker foam - without extra again to need glue.

IMPORTANT About the internal dimensions:

In the product description read:
"The specified internal dimensions of the case be approximately (L) 58 cm x (t) x 26.5 cm (H) 25 cm."

Unfortunately, when you SIDE OF PAGE measures, NOT from corner to corner!
But if you - like me - to sorting inserts built for wooden, which are 57,5cm long and 26cm wide, fit this NOT.

Reason:
The inside corners are glued by which the Neoprene lining like there overlapping is rounded and thus you lose length.
Thus, the box in the corners is not 58cm long, only 57cm.
In addition, the cap-holder are about 1cm deep into the interior.
A storage tray should max. 57cm long / 25.5cm in width - or you need to round out the application at the corners or cut the inner liner in the corners.
The really good lidholder I will unfortunately by a 50 daN strong, tear-resistant fishing line or flatter stand (available at hardware stores, if I can find any) must be replaced, because otherwise I do not purely my boxes / bring out.

You have the seller to concede that he at the internal dimensions "approximately" wrote.
Unfortunately, I am starting from the logic that "CA" in the context means that the minimum dimensions are given and the case rather a few mm or cm greater,
Did not come up with the idea that it is measured in the corners about 1.3cm small and are the cap holder on each side almost one cm into the interior.
Well ... my mistake, I've interpreted so because it seems logical to me to indicate the smallest dimension.

It would be nice yet a handle on the lid when the thing with content by 10 kg. weighs, it is no longer comfortable to wear with the two handles outside.
Because of the significantly inwardly lid holder, the chemical smell almost to 5 stars past.

Conclusion:
Buy recommendation what the price / performance ratio As for the price is really cheap with 29.00 but who wants to perfect it just also must dig deeper into their pockets.