Have the unit ordered last week, as always very fast delivery through Amazon. Unpacked and connected to my Philips 42pf9731. After a few minor problems with the Satfindung (Turksat 1C), I was able to customize the unit to approximately 3 hours as in the operation take it super worked. The activation of the HD + card went without a hitch. However, today after a week of operation denied me where the error message that would not support my TV HDCP, which manifests itself as the the station can no longer be shown. Not even the public service (temporarily times for 5 seconds, then error message HDCP not again no picture and sound) ... After intensive searching on the Internet (The Humax-digital.de page is a disaster without proper support or the times of answers the phone) no solution to find, since there is no software update for the Humax HD Nano is available. That with the "difficult installation" I had forgiven the device after a day when this message would not even come to show the normal SD channels after a week with the denial. I send it back and use my first Philips DSR 9005, even if it does not support HD +, I still stay with the public service HD channels. It can not be that you pay for a performance and is let down after a week. While Amazon may personally not for the device but can the manufacturer with the corresponding emphasis rather pass than the annoying single consumer. This was my 2nd and last Humax receiver ...