It started when stirring. Stir vigorously stood in the instructions. Great! After I had been alone conjured up a whole house with rough plaster, paint and wallpaper, I should have no difficulty in this, yes. Forget it. A thinner floor threatened to cancel, a thicker wooden schafftes it barely through the mush. So I had to ask my husband, who also had his work cut. after gur was touched, I tried my luck with the matching Molto scooter. How fortunate that I had a tool Arsenal with spatulas because the mush was almost not spread on the wall. So it had to play the good old putty. Combined box / scooters I got Although all applied, but it took far too long. In the desired 15-20 minutes which was not feasible. I would always have to look at the clock, and then remove the tracks in advance. Unfortunately, however, then you get back no clean transitions, since the mass then can be solved by the rubber pull up again, which results in unsightly little hole. If you have the mass applied fresh, the rubber puller can be a valuable tool. Next time I verspachtele again in a conventional manner and prefer simply to the squeegee over it. I would imagine that this could perhaps provide a fairly good result. But never again "Just plain" to the ground and the scooter.