Carton arrived, all packed very good, and more. The manual should be read through a meaningful way once since the latest for using the correct cover plates and Schräublein Common sense sometimes is not really sufficient. At AMD it's been on my board so that I had to fully expand it to remove on the back the existing metal plate and replace it with the Corsair. But this is done quickly and no problem.
When installing I noticed that the hose leads are not the longest. You have to build the fan with cooling element on the housing back. For the front of the tube is sufficient in my little case not even begin. This is generally not bad, but because I wanted to provide my new graphics card with a water cooling system and needs to be considered also at the back, a new planning Beginning to talk required.
What me at the quiet fan but not so like on the one hand the lack of marking of the airways (direction) and after the installation of this Once running at 100% which was too loud for me. You then can control solution with software it in the BIOS or in Windows, then everything is wonderful.
My AMD is operated in idle mode at approximately 26 degrees and under full load at about 38 degrees. Because there is in my opinion nothing to complain about. Positive is worth mentioning that not revving at full load the fan remains quiet but.
The installation time incl. Board remodeling and everything was about 30 minutes. So definitely doable. This conversion is recommended for less experienced PC screwdriver because you can not really go wrong with a little head and the operating instructions. I would buy the Corsair again.
