I use the device to operate my satellite receiver (VU + DUO²) from another room and Image + Sound to a TV to display there.
My previous solution via video streaming via network cable and play back on a fast modern notebook with SSD, 16GB RAM, very good graphics chip, etc. led, even under ideal conditions, but every now and then to stuttering. A friend had also not had good experiences with HDMI wireless adapters. All right, should now for me here a wired transmission.
This great set here, I can now the original HDMI signal transmitted through your house perfectly and smoothly at my flat screen TV and the receiver Remote control.
Connect between the transmitter and receiver, the receiver and 27 "LG flat-screen TV / Monitor with each other, are 20m Flat Cable CAT6 cables with simple design (CAT6 U / UTP) How to obtain them from Reichelt or Conrad or other electronic mailers.
I have tested, via a dual clutch even dazwischengehängt another CAT6 cable of 20m length and get a video camera signal with 1920 × 1080p (progressive) at 60 Hz frame rate transmit clean. Differences in quality to the original signal from the camera, I can not see; so it should be in the digital technology yes. And here it works even without interference or digital artifacts.
The two modules for the transmission of infrared remote control signals are not characterized by markings. The picture in the manual is correct, but is very small.
So: the module the infrared receiver of remote control signals can be seen at the open visible infrared diode, the module which radiates the signals again and the one mounted in front of the source unit is indicated by the curved hood that probably serves to scatter the infrared light signal.
Only at the beginning I had briefly stress because in the receiver box, a tiny lying around Lötrest for a short circuit on LAN chip made that resulted after the repositioning of the device and made sure that the device no longer intervened. Therefore, a point deduction. Fortunately, the device had but opened easily and by shaking the tiny narrow Lötfladen then fell out - from then ran again everything was perfect! Since the board is soldered but basically clean and because the device has ventilation holes on the sides, can penetrate through the debris, I suspect that this production error was really an exception. A layman would have set may be returned and no error would be the merchants by renewed tremors have been detected.