... Very easy to install and, especially since the tiles are extremely accurate cut. They are particularly suited to cover existing floor covering without having to replace it. My advice, however, depend on to move the tiles from the center of the room here (as advised in the instructions), because then you start on all the walls need to be cut. So rather (as actually at any floor) Starting from a corner, then avoiding the And here an addition to the manual, which is not a joke. It put the tiles in the oven at about 50 ° C for 20 minutes, then is both the adhesive and the linoleum very soft and the adhesive penetrates into all cracks and unevenness and the linoleum adapts to all bends, moreover, it is then much easier to cut. But watch out, by heating the material expands, so you should wait for the cooling before continues, there may be gaps. Takes longer, but it will be rewarded by a truly closed surface, the joints only shows when you look closely and if you know it. And an addendum, for that matter: the ground must not show any irregularities, and if it's only 10EL-mm, then there are massive problems with the joints, where then - it cleans and wipes, too - to fix dirt and gradually outwards occurs also are problems with the fit. For this reason, I would advise you to use when laying at least at the edges of adhesive to prevent.