The difference between free rotation and Zwangasmitnahme is considerable. In grinding operation with forced rotation, the material removal is higher by a multiple, according to Bosch 5 times as high. Is then placed still 40 or 60 on paper, the sparks fly. If forced rotation is disabled and sanded in the normal eccentric mode, so outer fine cuts with excellent surface quality are possible.
So much for the theory of how the machine kicks in everyday life and what can you do with it?
I have the GEX 150 Turbo used for the following work:
- Hulk Prepare partially for welding, making surfaces conductive for welds. Going in no time. Unlike the Flex can work at low speed, the surface is not so hot and the sandpaper does not clog as quickly.
- Sanded floorboards, 6m x 4m a freshly laid plank floor had to be ground flat. Actually, a task for a floor sander, but because of Bosch threw there, I just tried it with it. Went very well, the dust extractor with adapter and Protool VCP170 funktiert perfectly. Result is top.
- 50mm oak plate which had been installed as a bar in a round room sanded and rounded. Eben case very good result.
-Schiffsrumpf Polish, polished with a soft adapter plate and polishing Flies approximately 35m² hull. No holograms top surface.
-Diverse Small grinding work in wood surfaces, in Exzentermodus can really achieve extraordinary results.
Conclusion:
Very powerful machine with a wide range of applications also runs through hours, is doing well ordnetlich warm. Very robust construction, so far no tangible signs of fatigue. The machine is not easy to lead If switch-forced rotation, we need a strong hand, the machine makes a otherwise what she wants. Until you also very uneven surfaces processed without errors, it requires some practice, you do not fit in, so tilted the machine and runs away. Whoever has got used to the handling, saves a lot of time in the first place. Unlike other Getriebeexzentern allows the mode switch during operation. The device so you need not only Unignore, the gear ratio can be when the unit is on or off. I can edit an area only in rough grinding, the machine lifting short, put the lever and loop continues in Exzentermodus. It is also possible to switch from pure Exzentermodus when the unit is in coarse sanding with gear reduction. So can be tricky to master tasks extremely flexibly and quickly.
Special Feature:
- Soft start
- Speed selector constant electronics, works very well. Besides at maximum speed the Geräuschneiveau for as a powerful machine is surprisingly low.
- Additional handle
- Exhaust can be completely dismantled. Then the machine for polishing is very handy.
If there were still a protector similar to Rotex I had nothing to complain about. The machine is virtually unrivaled for its price. I would buy them again at any time.