The exuberant but very positive reviews I can only say: "Stay on the ground!". After all, is not that great dise wahrliche HELP! 1. you are holes all around 1mm in diameter too large, thus the drill already wobbles back and forth on its own, "vertically" is then thus a wide elastic term. 2. The slip stoppers are inserted too deeply, and so deny their part function. This I have underlaid with lock washers M6 and now they come to their function even closer. 3. When drilling hard materials has the small but drilling aid poor control, the thing tilts slightly away because you just can not exert a large lever. Drilling then the 6'er in the middle it gets fun, because the hand has only stop at the left or re narrow oval rim - or one (s) drilled for better grip by the hand ;-) Conclusion: Would it be to auction for a price, not sinnloß it on eBay, it would be gone. For the ton, it is me then too bad. 2 points are justified - give the 1Point Rezensionisten but as far right!
! Attention! Anyone who thinks here with drills for masonry to start something, you are wrong! These drills are in the shaft that is getting thinner because the Hartmetallplätchen always protrudes beyond the shaft in diameter. Possibly fits a 10 drills in the 8'er Drill spindle - with stem vorran mind you! I've used the part solely for woodwork - tries to use.
Great if accurate Tolerance of holes / guides and this even 1cm longer, anti-slip finish with function for better control of the base would be larger and the breakpoint regardless of the borehole diameter would.
I had to run with green anti-slip knobs and black drill guides, contrary to the figure.