atFoliX FX-Clear - with downsides

Slide set arrived quickly. Not bad for the camera on both displays. Unpacked and glued according to the instructions. Easy to use and relatively high-quality film, although I directly times einhake here and have to say restrictive that the film opposite the appropriate model for the 5dmark2 is thinner and does not fit exactly.

Put even after repeated and reposition again finally failed, that the Flie the surface of the display conforms and therefore the air will disappear between. Neit, it remains at the upper or lower edge (depending on how one sets the film) an air edge, where the sheet does not rest on approximately 4-5 mm width on the display. So only helps recut the manual to make the film narrower by about 0.1 cm. Then they fit, though the cut edges can be identified as such on closer inspection. I find that the fit could be better here and the thickness of the film should be such as in the model of the camera predecessor (5D2). The protection for the upper display contrast adjusts very well, although it should be noted that the display is slightly curved for belt attachment down and therefore is not liable, the film in this area. You notice it, but it hardly disturbs. Only by an optimal fit expected here as well, this would probably only with a softer film possible that conforms to the curvature better.

Therefore, only an average rating.