I have a black OnePlus One (64GB).
First, the positives: The bag looks very good, the material reaches good. The bag is tailored to fit in denersten days because very closely. But now the case has expanded to the correct size.
But now the negatives: The black OnePlus One has a rough back side and rough side faces. Thus, it does not slide into the lining, but the lining get stuck and is a bit pulled or lengthens the lining. Conclusion after 2 weeks: Today, the mobile phone slides into almost entirely because the bag and the lining have expanded accordingly, but the lining shrinks the bottom together. So it makes wrinkles that are naturally durchspürt and also from the outside look bad.
"Almost all" means that it comes to the crucial 2-3mm too far out looking up. With my phone fell down in his pocket again and unfortunately exactly on the top corner. - The bag could not protect the mobile phone - the metal edge of my cell phone now has a nice dent on. With a fitbag that would certainly not have happened, because the mobile phone 3, 4 infected mm further inside. I was pretty annoyed that I now am brand new cell phone have a loss because of the savings of a few euros.
The solution would have been to either bond the lining with the outer shell or mitzunähen at least below. Unfortunately, the lining infected but only loosely in the outer shell and inside is sewn only at the top. If you're unlucky, then one even moves to the cell phone, the lining with out and then hang a "perverted black socks" from the outer lining. The folding arms possible recapping of the lining in the outer shell is then not so easy.
Conclusion: Once and never again. A bag should look good, be easy to use and protect the phone. Adore can only the former, in the operation and the protection it gives a clear "Not enough" of me.
