First the good news: The motion detector is working properly in the dark; the LED is also from an adequate light for orientation .; the burn time is fine. So far so good. Incidentally, however, there are unsightly defects. The housing of the first light opened almost of its own accord; the housing of the second lamp was only with the aid of a knife to open as a lever between the two housing parts. After opening the two lamp chassis are filled with 4 AAA batteries or rechargeable batteries. In one of the two chassis the successive outer batteries were under such strong pressure in the socket, so that they also flew several times by itself. Since the two lights do not have an input or switch, they are going to, even if it is not desired. Because it naturally increases the power consumption, it is strongly recommended to use rechargeable batteries instead of batteries. With a double-sided adhesive strip can be attached to a smooth wall, otherwise the screws must be used. Since the lighting chassis is pulled down, this fell at the easy-open lamp due to lower terminal voltage by its own weight to the ground and the batteries were scattered on the floor. A strip of adhesive tape must therefore ensure a secure grip.
Conclusion: basic function very well, but, moreover, significant potential for improvement exists.
