Because it seemed to me a powerline solution because of the many separately fused circuits too uncertain, I decided for a repeater and indeed for the relatively expensive NETGEAR EX6200 in the hope that what what cost, is what. Since my Speedport router does not have WPS button, I expected a bit more complicated commissioning, should be to create thanks to the supplied Quick-detailed German manual but easily. In addition, one can imagine the very detailed, however English, operating instructions from the Internet Download. This is really exemplary, very accurate and really great detail. You can tell that it was written in the US.
The device then proceeded something bumpy, as was to be expected. You had to occasionally break off again and start over the process off and on again, but not a fundamental problem posed (for no points deduction). Finally, everything was to our satisfaction and to the repeater could be determined to carry around the house to find the best reception location for the router signal. That was not difficult, because the reception in the house was good to very good, despite dazischenliegender concrete ceilings. I finally decided on a central location on the ground floor. The repeater signal to be received with laptop or Smartphon on the whole land, so on the terrace or the furthest corner of the garden with good to very good signal strength. The repeater can, if it is not needed, be switched with a single touch on and off, which is convenient in order to minimize the electromagnetic radiation. After switching it finds its router immediately. I would recommend this highly enough part.