after one year of use, I can now the unit The following "properties" attest: 1) If the product * is not * turned, then ... a. ... If the battery is not loaded (something else is there? But I staun!) b. ... Carries out the operation of the "Cut" button means that the device has an increased power consumption and the battery is discharged (off mind you, that's device) 2) the internal processing is of subterranean quality, pay rich "tinker boards" hold forth to the making development blundering still sellable. the soldering quality is unacceptable, and rework on the board were obviously made with lead solder (allowed to do that at all?) 3) excessively long lead-ins and lead-outs for labels are only good for DYMO - me personally they do not help, because I have to trim all manually. 4) the pressure deep (or "Saturation") is transverse to the direction of pressure uneven. 5) the pressure rises deep laengs to the printing direction. This is "normal" print not very augenfaellig, but makes the inverse pressure (eg vollflaechig black with transparent lettering on a white label virtually impossible because the printer does not properly compensated, thus the term in laengsrichtung smeared wird.man the printhead heating So is not well to print between the wait because the device smart enough to compensate for print head temperature. 6) numerous laengsriefen in pressure can not be eliminated by careful cleaning of the print head. 7) Once manages a label, then adhesive strength and abrasion resistance not to be criticized, with regard to the promised screen resolution but probably all were squeezed shut eyes.