Pins 1 and 8 are connected to a 10uF capacitor, which causes the gain of 200. Before the capacitor is still a 0 ohm resistor - did not know that there is something.
Pin 3 (+ input) is connected upstream of the 10K potentiometer.
Pin 7 (Bypass) depends on a 10uF capacitor to ground.
Pin 5 goes through a 10pF and 100 ohm resistor to ground and through the 100uF capacitor according Out.
Tip: If the power source is not enough niederomig it comes to hum (known as motorboating, because it acts like a motorboat sounds.). Then a large Elko (eg 220uF) must be connected in parallel to the power supply.