Merely to change the memory card, the envelope must be folded.
As a solution lends itself to, the P1 easily via USB to respond as a mass storage.
Although the data transfer is slower than on memory card adapter,
if you but that opening the envelope, fiddly open the memory card door, insert the card into the adapter plugged into the computer and everything backwards again with reckons,
it is still the faster solution.
At the, already mentioned here, '' 'sharp' '' edge at the edge:
My hand looked after the first operation like a slaughtered pig (irony-end)
In Earnest. When my shell is an edge 'noticeable'
I could remove with the nail file by two strokes.
But I do not because I find it personally quite pleasant.
Are there extra grip and is also anything but sharp (silicone !!!)
Otherwise, I find very pleasant that the volume buttons and the inputs can be found on / off better than no cover.
In addition, the P1 is so flat that the one-hand operation already requires a certain willingness Risk without shell.
Through the sheath and the camera almost does not lie on the table.
I have attached the left and right of the lens two small raised rubber label.
Thus, the lens does not scratch around on the table.
In addition, you can put the envelope the P1 with the display on the table.
The border around the display's prevented that the display touching the table.
Of course, it should not lie in the beer puddle anyway :-)
Oh, if drawn out from his pocket the edge of the display is also very helpful.
And while holding between his lips also :-)
For me, the envelope is an essential accessory which greatly increases the handiness and the protection of mobile phones.
One mentioned herein damping of the microphone, I have personally not experienced.
Maybe there was the little finger on the microphone.
