Two things struck me something negaitv:
- On the one hand, the protective film has been removed on the writing surface on the edges not good (without being cut with a sharp object on the aluminum frame along to some residues could not be separated from the whiteboard).
- On the other hand bothers me personally the mounting method. The Board has in each case a hole through which a screw (included) to be screwed into the wall at the four corners. Appropriate plugs are also available. That the size of the anchor exceeds the diameter of my Standardbohrköpfe I can criticize bad, but should be noted.
One or the other, it is perhaps seen as an advantage that in this way any angle or other brackets are externally visible on the whiteboard, but dismantle Later this variant is less favorable. This is especially true if you then put the four included cover slip on the holes.
The Assembly should also necessarily be made in pairs to ensure a horizontal position as possible. In addition, these Konsturktion requires that you hold the whiteboard and screwed simultaneously.
Conclusion: For the 90x120 - Board the price-performance ratio is super. (The size is also sufficient completely for the local study.) Because of my opinion not entirely thought out holder and the film residues a point deduction
By the way: The prices for the larger boards are coated insane. With two smaller boards you is significantly below the price of 120x180 boards. The pen holder is the way 3cm wide and 45cm long. It fit so without further effort it 6 pins. It can be installed on both the long and the short side (is guided in a rail, a little loose, but that's fine).