I moved into a new, small city apartment. On the 40m² of living space, it is important to accommodate as many items to save space. This is a challenge, especially in the kitchen.
When I receive the item, I wanted the holder hook in the wall cupboard of a Swedish manufacturer and quality equal to make a hook behind the "kitchen roll on". And then it turned out quite differently ...
Before you buy the item, you must you be on the following clear:
- The holder is not very stable, but looks through a uniform layer of chromium appealing. When unrolling the toilet paper absorbs the entire frame, which is why you needed to roll two hands. If no problem, with which one could not live ...
- The holder has a rubber coating at the upper edge. One would think that it was a clever idea that the holder does not slip or scratch the cabinet. To the extent that is true. But the holder is about 5mm thick through the gum. Even in my Swedish quality cuisine are the gaps max. 3 mm. Therefore, after "Holder Assembly" the door not be closed ... This gives two options:
a) peeling the rubber layer and hope not to damage the holder.
b) Move the door leaves on surge upwards and assemble there. The overall picture, however, looks a 0.5cm wider gap between door and cabinet genuine sch **** out ...
Long story short: only moderately suitable for cabinets with doors. Rather than using for open rack systems.
Hope you have helped in the decision.
Have a nice day and best regards