The items are well packed, I especially liked that all screws and washers were in a labeled packaging and the label on the package exactly those used in the assembly instructions corresponded: Wonderful and "foolproof". So it was not a problem that the instructions contained no text, only (some small side) image.
The star deduction is that the spacer (that is the part of the image at the bottom right), the screw could not be sunk properly, which means that the locking of the spacer does not work because the wire ends that go in in the spacer, from screw head are pushed too far to the outside. I think this is a design flaw (I should have been only too stupid, I am of course grateful for every suggestion). I also seemed the screws that are sunk (with plugs) in the wall, a little too thin, they were not fully tighten, but went mad, although the hole for the dowel was just right and definitely not too far. I have these screws therefore replaced by 0.5 mm stronger screws that held better and no longer rotate through.
If you have installed everything for no more than 20 - takes 30 minutes (even in a weak gifted artisans like me) you just hang the flat screen TV as a picture on the wall. Works fine.
One should either possible all cables have already plugged into the back of the TV or the position of the bushings remember exactly. Because if the member hangs, it is extremely inconvenient to mount behind a bit and you can see even with the extended spacer almost nothing. This of course is the "hook" if you look at extremely close decision to be mounted on the wall. But that is not a defect, but rather the logical consequence of this type of installation, which is the best looking for me because of the TV hangs really flat on the wall.