Cools Xeon E3-1260L in Miditower

I have the 92mm fan as a case fan and the 120mm fan on the heatsink in use. The mid tower is quite small, so no tower heatsink is possible. Both fans are limited on the Low Noise Adapter (LNA) to 7V and thus in idle (idle) at 400 to 600 revolutions and inaudible to half a meter. Under full load, they are then very audible (1200-1400 rpm), but not whistle.

Included + Thermal Compounds
+ Both PWM 4-Pin fan that can be combined in any way or otherwise use in my case.
+ Ease of application. Detailed instructions included.

Noctua fans have been successfully used in all my computer.

Please note:
You have to make sure that the RAM memory modules are not too high. With standard modules without the high heat sink not a problem. Pictures of this can be seen on the page (link below).
The backplate, if necessary, can wiedermal cause the motherboard needs to be strengthened.

I helped the following review:
[...]