Where what goes, you can see when you visit the items already. But the direction of water flow on the terminals should be marked clearly on the cover. The assembly went smoothly thanks to Teflon tape, rubber hammer and screw clamp. But I just decided to let the pump by the dry-assembly only once a day and a night stand so and to then connect and fill. Why? Since setting up the cover in the corresponding slots (especially chamber partition) is somewhat tricky when new and the strap should einliegen something. This then everything went wet fix and easily. You should tighten little by little emotional in the first few days but already the clamping screw. If the standing below the water pump starts, sound (yet?) A brief screech farting while about 1 liter of water is pushed to one side of the pressure vessel in the short term through the ring seal under the tensioner to the outside. (If that does not change, I'll have to turn the tension bracket again to prevent this "Zwangsentlüften".) After that everything runs very smoothly and quietly. But it is a pity that can not be 2 daily programs with the timer set. Solving the problem is with me the 24-hour operation and my wireless network switch. In a few days the solar pool heater is still connected. If all goes as expected: perfect. Am looking forward to the first cleaning of the pool, as I previously had to make at much lower pump power! Would have like 4 and a half star (s) awarded; since that is not possible, I decide. 5
Update: The "farting forced ventilation" was gone for 14 days and every now and then retightening the ring, everything is now tight. The clamping ring probably needs some time to einzuliegen. The solar pool heating I via an adapter and a 3-way valve (psc = 1) connected. Everything works perfectly.