Unfortunately, the assembly is thoroughly gone wrong. This could of course be due to my rough Moto Riker vein, but I had another screen protector with identical "Installation" manual, no problems.
The film is unfortunately extremely accurately (actually positive) they also require extreme precision when placing. Sitting the thing wrong a 1000th of degrees, you realize the whole only because the non-removable large bubble is formed at the end on the side.
According to the assembly instructions can be repeated by the film is easily removed and reissued. However, the problem is then the carrier film is, of course, from one thus inevitably small Verunreinungungen (unless you have your own clean room) applies, which only conjure up no later than the 3rd attempt at a film a beautiful bubble pattern.
Also mentioned in the instructions rinse under water does not help much. Dries the rinsed film at the air, then water spots make you (perhaps klappts with distilled water better) dabbed it with paper or textile cloth, as lint and small dust particles remain on the tacky side, of course, depend what negates the purpose of rinsing completely ,
I must confess that, bought the same film a friend of mine and had absolutely no problems, so maybe it really was just me, so I can not necessarily advise against a purchase, however. Also, I am aware that there will be hardly an easier way to apply such films, which means that the manufacturer is not at fault. So this here is at best constitute a review.
All in all I had bought 3 films which all were unusable after a few attempts in principle.
And the best part is, I will now order a 3-pack, because I the result, Somal installation succeeds, as very good feel.
So I will be the next test of my film talented girlfriend perform, in the hopes that it has acted in its mounting not just a stroke of luck.
