The installation works just like conventional fluorescent tubes. They are allowed to slide at both ends with the contacts in the groove of the holder and rotates it by 45 degrees. Previously, the necessary for conventional fluorescent tubes Starter element must be removed and replaced with the supplied conformal LED backup if power is off, however. That's it then.
This valve also offers the possibility of varying the direction of radiation when required. You have to understand that unlike conventional tubes, the light is not emitted all around here, but only by a narrow strip at the bottom which allows an angle of 120 °. By simplem sliding and revolving mechanism, which is mounted on both ends, you can, even if the tube is already mounted, the orientation of light vary by rotating the tube body between 15 ° and 90 ° to the left or right. In our case, that was not necessary, but depending on the room and working situation so can an optimal illumination can be achieved.
The light color tends bluish between white and light. The fall in the space in which I use the tube adjacent a second equipped with conventional tube technology ceiling lamp, already on, because the light of the conventional tube is yellow and is also just around radiated. For rooms with more lamps, which are used intensively, I would therefore change all the tubes to LED, otherwise a little more homogeneous light impression can arise.