Neutral:
+/- Additional lumbar cushion
+/- The tilt mechanism is initially very hard, but is also softer when locks the tilt mechanism and so can live 1-2 days
_________________________
Cons:
- The seating area is quite hard, which makes long sitting very uncomfortable, especially if you have little meat on the butt
- Components partly not fit, is either a general design flaw or a manufacturing defect
- The tilt mechanism and the armrests are so closely sized to the assemblage of the arms is difficult or impossible, depending on the slots are exactly as in the armrests, since the screws come already at the slot edge (design flaw)
- With me some of the screws were wrong (wrong) been turned into thread, thus the thread was only stiff and then stripped.
- The seat height is so high that people under 180cm likely find it difficult to push their way in to sit with your feet through the area
- The armrests are shaky and can not be adjusted in the side, with my left was something wrong that clacked every time I put my arm a little harder on it.
- No ordinary headrest, the included pillow is a joke, because the cheap plastic filling fluff (fine plastic threads) out. I zweckentfremde here the lumbar cushion, as larger and more comfortable
- The total number of these chairs is only available in cheap leatherette
_________________________
I have this chair purchased directly from HJH-Office, because I wanted to spend on a chair by NFS no 360. In addition to this, this chair is a combination of the Office COMFORT Series and PRO GAMING & OFFICE series.
The structure did not prove very gratifying, because actually let the armrests good mount. Here the holes have been utterly wrong sized, although the armrests are already equipped with slots, it does not fit properly. In addition to this, some screws were incorrectly turned into thread, thus the thread has zerdreht, the screws were hard to get out again, and did not look very dolle from (already tapered threads feeding available). The re-tightening designed accordingly unhealthy thread overexcited, some screws were not tighten properly, just tripple * facepalm *.
Well I thought maybe a Monday model, so I asked for a replacement.
The second attempt failed even during the installation of the tilt mechanism, it did not work, hole size does not match.
Again, the holes were wrong again for the armrests, ergo I'm going for a general design flaw that is apparently noticed in production or anyone, or do not keep them a change necessary, since it just fits so.
Quality control we do not seem to be in production, also do not seem to be mounted the chairs for the sample. A real indictment of the manufacturer.
I can only guess at buying an eventual replacement to prepare, or two.